An introductory training program for microcontroller-based product development and embedded engineering.
Consumer electronics training courses
Domestic consultation number: 021-51.36000
Telephone call, Toronto, Canada: +1 2895730138
For the population: the most basic level of entry, with a view to developing single-piece products
Uses processor: 51 microcontroller
Programming language: C language
Task:
1 Designs the rationale and circuit boards according to demand and processes them
2 Development of writing procedures, online debugging, testing of product functionality and modifications
For the first time, participants were exposed to functional analysis based on the products of other manufacturers, the selection of models according to the market supply and price of components, and the design of an optimised programme to meet the cost requirements.
Noise wave atomizer: 4 lessons
The fogster is very simple, but there is a certain challenge in meeting the cost requirements. It involves the coordination frequency, the pressure-resistant selection and drive of the MOS tube, software to simulate hardware to produce PWM, etc., and how to balance the resources within the film to design the software.
Foot massage controller: 6 lessons
Learn to design a 220V turn 24V switch, including a switch transformer design and a voltage-based circuit based on uc2842, with feedback control over the switch. Design a single plate control panel. Learn the code for infrared reception, the PWM drive for the electric power, and the design of the drive mode (i.e. a motor to imitate massage techniques).